Skip to content
▪ JetLabel 1.2.0 · Mac, iPhone and iPad · 7-day free trial · Pro: one-time in-app purchase
JetLabel™
Features Barcodes Printers Pricing FAQ Highlights in JetLabel 1.2.0 Try free for 7 days
Printers · GoDEX

GoDEX G330 on Mac — Setup & Label Printing with JetLabel

Limited on Mac

The GoDEX G330 is a 300 dpi label printer from GoDEX that uses ZPL. On Mac, JetLabel prints through the macOS printing system, so the printer needs a working macOS driver. Driver support for the GoDEX G330 on macOS is limited; check it before you buy. On iPhone and iPad, JetLabel can send ZPL directly over the network (port 9100) if your model has Ethernet or Wi-Fi.

Try JetLabel free for 7 days
GoDEX G330 — spec sheet
Protocol
ZPL
Resolution
300 dpi
Interfaces
USB, RS-232, opt. Eth
macOS driver
Limited
iPhone & iPad
Network printing (ZPL, network models)
Recommended
60 × 30 mm, 100 × 150 mm

Printing from iPhone and iPad

JetLabel on iOS and iPadOS supports AirPrint and suitably configured network label printers using supported protocols. Check the printer and its network configuration before printing.

Each model page shows whether the printer works on Mac with its macOS driver and whether direct network printing from iPhone and iPad is possible. The ratings are based on manufacturer specifications. Brother QL and Bluetooth direct printing are not supported on iOS.

Does the GoDEX G330 work on macOS?

Possibly. JetLabel prints through the macOS printing system, so it depends on a working macOS driver, and driver support for the GoDEX G330 is limited. This assessment is based on the manufacturer’s specifications, not on a test by JetLabel. Try it with your printer during the 7-day trial.

And on iPhone and iPad?

On iPhone and iPad, JetLabel can send ZPL directly over the network (port 9100) if your model has Ethernet or Wi-Fi.

Setup

Set it up on your Mac.

  1. 01 Download and install the macOS driver for the GoDEX G330 from GoDEX.
  2. 02 Connect the printer to your Mac and add it in System Settings → Printers & Scanners.
  3. 03 Load the labels and calibrate the media on the printer.
  4. 04 In JetLabel, set the label size to match the loaded labels.
  5. 05 Choose the GoDEX G330 as the printer in JetLabel and print a test label.
FAQ

About the GoDEX G330

No. JetLabel prints on Mac through the macOS printing system, so the GoDEX G330 needs a working macOS driver.

On iPhone and iPad, JetLabel can send ZPL directly over the network (port 9100) if your model has Ethernet or Wi-Fi.

Print to your GoDEX G330 today.

Try JetLabel free for 7 days

GoDEX is a trademark of its respective owner. JetLabel is independent and not affiliated with GoDEX. Compatibility information is based on manufacturer specifications and has not been individually verified.